What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
rivet with a simple structure includes a rivet cap, a rivet main rod, a rivet limit rod and a limit hole. The rivet main rod is provided with a limit hole inside, the rivet limit rod is located below the rivet main rod, the upper end side of the rivet limit rod is provided with a limit groove, the limit groove is connected with the lower end of the rivet main rod, and the groove surface of the limit groove is round. arc-shaped, the lower end side of the rivet limit rod is provided with four limit grooves, the cross section of the limit groove is in the shape of a right-angled trapezoid, the limit hole passes through the interior of the rivet limit rod and the rivet main rod, and one end of the limit hole The hole surface and the lower end surface of the rivet limit rod are on the same plane.
In the prior art, after the screw is screwed into the workpiece, rust inhibitor is dripped on the edge of the screw to prevent rust in the later stage, but this traditional dripping method of rust inhibitor often produces rust inhibitor during the dripping process. Difficult to penetrate, or the problem that the anti-rust oil cannot penetrate due to the tight contact between the screw thread and the thread groove. In terms of material saving, the traditional anti-rust of screws often causes a lot of waste of anti-rust agent, and cannot achieve a good anti-rust effect of screws.
The middle pins on upright and horizontal pianos are also called balance pins. The middle pins are installed on the middle sleepers of the keyboard frame and play the role of fixing the keys. Generally, there are 88 keys in the piano. The pins are matched with the pin holes, and the keys are installed on each middle pin one by one through the pin holes. Due to the large number of middle pins and keys, in the production and installation process, in order to ensure the flatness of the 88 keys after installation, it is necessary to debug the middle pins and keys one by one, or add paper circles to the middle fixed part on the middle pins. The flatness of the 88 keys is kept the same. This debugging method is extremely cumbersome and increases the workload of debugging. Moreover, when adding paper circles, the keys need to be disassembled frequently. Due to the limitation of the installation space of the keys, it is troublesome to disassemble the keys, and it is easy to install and disassemble the keys many times. Damage to the pin holes on the keys, degrading the quality of the piano.
The materials of rubber gaskets are usually NBR (nitrile butadiene rubber), SBR (styrene butadiene rubber), HNBR (hydrogenated nitrile butadiene rubber), EPDM (EPDM rubber), SILICONE (silica gel), VITON (fluorine rubber), CR ( Neoprene), FFKM (perfluoroelastomer), etc.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
