Service HotlineBirminghamHexagon head bolts are divided into two types: outer hexagon bolts and inner hexagon screws. According to the force mode of the connection, there are ordinary ones and those with reaming holes. The bolts used for reaming holes should be matched with the size of the holes and are used when receiving lateral force. According to the shape of the head, there are hexagonal head and round head. , square head, countersunk head, etc. Generally, the countersunk head is used in places where the surface is smooth and no protrusions are required after connection, because the countersunk head can be screwed into the part. The round head can also be screwed into the part. The tightening force of the square head can be Larger, but larger in size. Hexagons are the most commonly used. In addition, in order to meet the needs of locking after installation, there are holes in the head and holes in the rod. These holes can prevent the bolts from loosening when they are subjected to vibration.
When used for the connection and fixation of doors, windows, cabinets, etc. involving hinges, the traditional screw fastening method is usually used, and the screws are directly driven into the screw holes of the connected parts, and the screw end caps are directly exposed, which not only affects the connected parts. Moreover, the end caps of the screws exposed for a long time are easy to rust, and there are burrs in the end processing of the general screws. When used for fastening connections, the end caps of the screws are easy to scratch people, which affects the appearance and is not safe.
The BirminghamBirminghamspring washer can prevent loosening and increase the pre-tightening force, while the flat washer does not have this function. It can be used to increase the tightening contact area, prevent the friction between the bolt and the workpiece, and protect the surface of the connector to prevent bolts. The surface of the workpiece is scratched when the nut is tightened. However, for some important connections, such as places that rely mainly on compression to generate frictional force to transmit power, spring pads cannot be used, and the rigidity of the connection is reduced, which is prone to accidents. Spring washers can be omitted. When the strength of the connected parts is low, use flat washers or Birminghamflange bolts to increase the contact area. When there is vibration, pulse, and the temperature of the medium fluctuates greatly, BirminghamBirminghamspring washers must be used.
The existing method of tightening large screws is generally 1. After the nut is screwed to the connected piece by hammering + nut angle method, use a casing to connect the lever arm of the wrench, or use a free hammer to hammer the plate handle, Rotate the nut an additional angle to obtain the required preload. This is not only a primitive and labor-intensive fastening method, but also has great limitations, such as limited space, or the screw itself is a rotating shaft and so on, it is difficult to use this method.
It is used for fastening in the machinery, construction and electrical industries. One end is a hexagonal head for wrench tightening, and the other end is a thread. According to different thread lengths, it is divided into full thread and half thread, abbreviated as: GB bolt.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: external hexagonal flanged toothed screws, R-shaped R-type rivets, butt-locking screws 304 double-strand rivets, JB4331 hexagonal slotted nuts and other products, we can provide you with fastener solutions that are suitable for you.
