Service HotlineIn order to solve this technical problem, Yueluo Company provides an adjusting nut, which includes a bearing unit, a thrust washer, an adjusting nut and a snap ring. The inside of the adjusting nut is an internal thread structure, and one end of the internal thread structure is provided with Ring groove, the snap ring is pressed into the ring groove with interference, and is rigidly connected with the adjusting nut without relative movement; the bearing unit is supported on the shaft, and the thrust washer is in plane fit with the bearing unit; the adjusting nut and the shaft are threadedly connected , Fit with the thrust washer plane, the inner diameter of the snap ring and the thread of the shaft are in interference fit.
through-hole mounting nut, comprising a hexagonal portion 1 and a cylindrical portion 2, a threaded hole 3 is provided between the hexagonal portion 1 and the cylindrical portion 2, and two grooves 4 are opened on the cylindrical portion 2, and each of the two sides of the groove 4 has a The raised side 5, the two sides protruding from the sheet metal part 7, if squeezed or hit by the bolt 8, it will bend to both sides and buckle on the sheet metal part, so that it is not welded directly. Rubber can also be used. Each of the upper surfaces of the side edges 5 is provided with a convex point 6 so that the hammer will not slip when hitting.
In the switchgear of high and low voltage power equipment, the surface of many switchgear shells is painted or sprayed with plastic, and the installation beams and other parts of the switchgear and the entire cabinet must be continuously grounded according to the requirements of switchgear standards to improve the safe use of equipment. Because the common screw, Los AngelesLos Angelesspring washer, flat washer and nut type structural connection between the surface of the shell and the metal mounting beam cannot meet the requirements of grounding continuity, in order to meet the requirements, the surface of the shell is painted or Before spraying, special grounding studs must be welded. With the increase of installation beams, the number of welded studs must also increase, which increases the complexity of the product processing technology, wastes man-hours and increases costs.
The purpose of Guangdong Yueluo Hardware Industry Co., Ltd. is to provide a fastener with a new structure with a nut, which cannot be tightened by conventional tools during use, and is suitable for special occasions requiring anti-theft.
In the switchgear of high and low voltage power equipment, the surface of many switchgear shells is painted or sprayed with plastic, and the installation beams and other parts of the switchgear and the entire cabinet must be continuously grounded according to the requirements of switchgear standards to improve the safe use of equipment. Because the common screw, Los AngelesLos Angelesspring washer, flat washer and nut type structural connection between the surface of the shell and the metal mounting beam cannot meet the requirements of grounding continuity, in order to meet the requirements, the surface of the shell is painted or Before spraying, special grounding studs must be welded. With the increase of installation beams, the number of welded studs must also increase, which increases the complexity of the product processing technology, wastes man-hours and increases costs.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: half-button screws, half-moon washer/half-circle washer/half-moon nut, external sawtooth, round head straight handle bolts and other products, we can provide you with suitable products Your fastener solution.
