Service HotlineOn the other hand, when assembling many pin installation mechanisms, one end of the pin needs to be installed into the hole or arranged in the hole, and then the other end of the pin is applied to the pin through the pin installation mechanism, so that the pin is fixed in the hole. In the hole of the hole type product. This fixing method is not only extremely inefficient. And it is not possible to install multiple pins at once. Especially when exemplified at the other end of the pin, since there is nothing to hold the pin stable when the pin enters the hole type product, when force is applied to the other end of the pin, the pin can easily bend and damage the pin. .
The paint mixing mixer used for color matching in the auto repair industry uses a multi-link connection transmission as the main driving force. The transmission of torque has higher quality requirements for the impact resistance and fatigue resistance of the cotter pin. During the use of the cotter pin, it was found that the cracking phenomenon occurred due to insufficient strength, resulting in the machine not running. In the existing multi-link transmission mode of the paint mixing mixer, the connecting rod drives more than 10 paint pots in each layer of the frame to stir, and the bottom connecting rod is also responsible for the transmission of the torque of the upper connecting rod, which leads to the connection between the connecting rod and the connecting rod. The pins connected by the rods must have strong impact resistance and fatigue resistance, and must have a certain anti-loosening function.
Spring washers are often called spring washers in the screw industry. Its materials are stainless steel and carbon steel, and carbon steel is also iron. The commonly used spring washers are M3, M4, M5, M6, M8, M10, M12, M14, M16. These specifications are more commonly used. The national standard for spring washers is GB/T 94.1-87, which specifies standard spring washers with a size of 2-48mm. Reference standard GB94.4-85 Elastic Washer Technical Conditions Spring Washer
The existing combination screws and accessories are individually processed and then handed over to the customer for assembly. This method is prone to assembly problems, and the combination screws and accessories need to be marked with identification marks, which increases the production cost.
During the daily use and operation of mechanical equipment, due to the influence of external load, internal stress, wear, corrosion and natural erosion, individual parts or the whole change size, shape, mechanical properties, etc., which reduces the production capacity of the equipment. The consumption of raw materials and power increases, the quality of products decreases, and even personal and equipment accidents are caused. Therefore, in order to make the machinery and equipment can often play the production efficiency and prolong the service life of the equipment, the equipment must be properly repaired and routinely maintained.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: anti-slip bolts, blind hole rivet nuts, ladder nuts, hook screws and other products, we can provide you with suitable fastener solutions for you Program.
