Service HotlineGenerally known bolts refer to screws with a larger diameter. According to this statement, the diameter of screws is much smaller than that of bolts. Stud bolts do not have a head, and some are called studs. Both ends of the stud are threaded, with no thread in the middle and a smooth rod in the middle. Studs are used on large equipment such as gear racks. In actual use, the external load will have vibration and the influence of temperature will reduce the frictional force, and the threaded connection will loosen and fail over time. Therefore, it is necessary to do a good job in the maintenance of the stud bolts at ordinary times. Stud bolts or anchor bolts will have problems under the action of mechanical friction for a long time. When problems occur, the engine oil pan should be removed, and the use of the engine bearing bushes should be carefully checked, and the clearance between the bearing bushes should be checked. Whether it is too large, if the gap is too large, it should be replaced in time. When replacing the stud bolts, also replace the connecting rod bolts. When some large equipment such as nail making machines are in normal operation, if they find that the engine is not running very stable or there is abnormal noise, they should stop and check in time to avoid bigger problems.
The upper part of the T-bolt is a screw rod, and the bottom end is a T-shaped head. It is equipped with a sleeve with an anchoring plate. The fastening equipment is installed by the anchoring force between the T-shaped head and the anchoring plate. The appearance of the equipment after installation is shown in Figure 1, in which the figure composed of black lines is a component composed of T-bolts and integral sleeves. When constructing civil foundations, the sleeves should be pre-buried first, and the T-bolts will not be used until the equipment is installed. Anchor into the sleeve.
In order to achieve the above purpose, the technical scheme adopted by the screw in Yueluo Company is as follows.
A screw can be equipped with only one spring washer or only one flat washer, or it can also only be equipped with a two-piece combination of flower teeth. The national standard number of the combination screw is represented by GB9074. The commonly used cross recessed small pan head three combination screw national standard is GB9074.8. This .8 refers to the small pan head. That is, the size of the head of the pan head screw that is often said. Denoted by letters as PM. Professional combination screw manufacturers, the habitual expression method is three-in-one PM. The commonly used cross recessed large pan head combination screw national standard is GB9074.4. Professionally called large pan head combination screws. Or R head, or B head. That is to say, the head of this combination screw is larger and thicker than the head of the small pan head combination screw. There is also a commonly used external hexagon combination screw, which is a cross external hexagon combination screw. It is often called a socket hexagon combination screw. The national label is GB9074.13.
The process factors that affect the quality of high-strength fasteners include steel design, spheroidizing annealing, peeling and dephosphorization, drawing, cold heading, thread processing, heat treatment, etc., and sometimes the superposition of various factors.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: black pin shaft GB882 pins, POM washers, vertical stripe rivet nuts, T-block t-slot pressure plate nuts and other products, we can provide you with Provide the right fastener solution for you.
