Service Hotline5. After the closing value material and the geometric parameters of the nut are determined, the change of the closing value has an important influence on the repeated use characteristics of the lock nut. When the closing value becomes larger, the deformation of the threaded piece increases, the strain of the threaded piece increases, the strain cycle hardening phenomenon intensifies, and the pressure FN of the threaded piece increases, which has a tendency to increase the unscrewing torque; on the other hand, the width of the threaded piece decreases. , the total area of the threaded piece decreases, the friction with the bolt decreases, the strain of the threaded piece increases, the low-cycle fatigue performance decreases, and the maximum unscrewing torque tends to decrease. Under the combined action of various factors, the change of the maximum unscrewing torque with the number of repeated uses is difficult to predict, and it can only be observed through experiments.
The existing automobile fastener nut is a common nut. After the nut is matched with the bolt, during the tightening or disassembly process, there will be a phenomenon of sliding wire, and the safety factor is relatively low; It is difficult to guarantee, easy to rust, requires frequent inspection and replacement, and increases the cost of using the car, which can no longer meet the needs of the market.
The installation of the pressure riveting nut is exquisite. If the installation method is not correct, the riveting will not be firm after the pressure riveting. For example, one of our customers reported that the nut would fall off after riveting. Our technicians found that many customers hit it with a hammer or other impact methods, because the installation method of the riveting nut will cause pressure. The uneven force of the rivet nut seriously affects the riveting effect. It looks like it is pressed in on the surface, but in fact, the flower teeth of the rivet nut are not riveted with the plate at all, so it is definitely not riveted. To install the rivet nut, you must use special installation equipment, or simply install it with a press and stamping equipment (generally factories will have these simple equipment).
Screw: A type of fastener consisting of a screw head and a screw rod (a cylinder with an external thread), which needs to be used in conjunction with a nut to fasten and connect two parts with through holes. and widely used in people's lives. In real life, due to the vibration of the machine, the workpiece is loose at the connection between the screw and the nut, and the nut needs to be tightened frequently, which is time-consuming and laborious, delays time, and reduces the production efficiency, so how to reduce the production process. Frequent tightening of screws has become an unsolved problem for people. Therefore, there is an urgent need to provide a slotted screw.
Round head three-combination screws are also called pan-head three-combination screws, which are divided into large pan-head three-combination screws and small pan-head three-combination screws. The materials are divided into stainless steel and iron. The stainless steel round head three-combination screws include stainless steel small pan head three-combination screws and stainless steel large pan-head three-combination screws. The national standards are respectively expressed as GB9074.8 and GB9074.4.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: nameplate rivets, good pass and stop gauges, sealing gaskets, screws with mesons and other products, we can provide you with suitable fastener solutions for you .
