Service HotlineCommonly used standards are broadcast. For hexagonal nuts, the commonly used standards are: GB52, GB6170, GB6172 and DIN934. The main differences between them are: the thickness of GB6170 is thicker than that of GB52, GB6172 and DIN934, commonly known as thick screw cap. The other is the difference between the opposite sides, the opposite sides of DIN934, GB6170 and GB6172 in the M8 nut series are 13MM smaller than the opposite side 14MM of GB52, and the opposite sides of M10 nuts, DIN934 and GB52 are 17MM. The opposite side of GB6170 and GB6172 should be 1MM larger, M12 nut, DIN934, GB52's opposite side is 19MM larger than GB6170 and GB6172's opposite side 18MM is 1MM larger. For M14 nuts, the opposite side of DIN934 and GB52 is 22MM, which is 1MM larger than the opposite side of GB6170 and GB6172, which is 21MM. The other is the M22 nut. The opposite side of DIN934 and GB52 is 32MM, which is 2MM smaller than the opposite side of GB6170 and GB6172, which is 34MM. (Besides the thickness of GB6170 and GB6172 are the same, the width of the opposite side is exactly the same) The rest of the specifications can be used in general without considering the thickness.
[In a preferred example of Guangdong Yueluo Hardware Industry Co., Ltd., the cone includes a large diameter end and a small diameter end, the diameter of the large diameter end is the same as the diameter of the inner hole in the middle of the nail body, and the diameter of the small diameter end is Two-thirds of the diameter of the large diameter end.
According to an aspect of Guangdong Yueluo Hardware Industry Co., Ltd., a rivet insertion mechanism is provided, including a pressure cylinder, a pressure shaft, an insertion nozzle, a bottom plate, a fixing block and a rivet fixing mechanism, wherein one end of the pressure shaft is connected with the pressure cylinder, and the other end is connected with the pressure cylinder. The insertion nozzle is connected, the fixing block is sleeved on the pressing shaft, and is fixedly connected with the bottom plate, the rivet fixing mechanism is installed on the bottom plate, and the insertion nozzle extends into the rivet fixing mechanism and can extend from the rivet fixing mechanism.
Convex washers are mainly punched out of iron plates. The shape is generally a flat washer with a hole in the middle. Flat washers are usually thin pieces of various shapes to reduce friction, prevent leakage, isolate, prevent loosening or Dispersing pressure, the rationality of its design structure and the safety during use are very important.
Anti-loose washers are also known as anti-loose washers, self-locking washers, self-locking gaskets, DIN25201 anti-loose washers, double-stack self-locking anti-loose washers, double-stack wedge-type anti-loose washers, etc.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: set half-tooth bolts, 7380.2 screws with pads, round pads, hexagonal joint nuts and other products, we can provide you with suitable fastening products piece solution.
