your location: 首页>>News>>Industry News

Service Hotline

+86760-8787 8587

Customized 12.9 grade fine tooth machine meter screw headless hexagon socket set screw 3/4 5/8

author:[email protected] Click:6170end source: time:2023-06-11 17:57:29

Summary of information:We have more than ten years of experience in screw industry production. The main products are: lengthened and thickened ...

Fasteners are a type of mechanical parts that are used for fastening connections and are widely used. Fasteners are used in a wide range of industries, including energy, electronics, electrical appliances, machinery, chemicals, metallurgy, molds, hydraulics, etc., in various machinery, equipment, vehicles, ships, railways, bridges, buildings, structures, tools, instruments, etc. , chemical industry, instruments and supplies, etc., you can see all kinds of fasteners, which are the most widely used mechanical basic parts. It is characterized by a wide variety of specifications, different performance uses, and a very high degree of standardization, serialization and generalization. Therefore, some people also refer to a type of fasteners that have been standardized as standard fasteners, or simply referred to as standard parts.

On the other hand, when assembling many pin installation mechanisms, one end of the pin needs to be installed into the hole or arranged in the hole, and then the other end of the pin is applied to the pin through the pin installation mechanism, so that the pin is fixed in the hole. In the hole of the hole type product. This fixing method is not only extremely inefficient. And it is not possible to install multiple pins at once. Especially when exemplified at the other end of the pin, since there is nothing to hold the pin stable when the pin enters the hole type product, when force is applied to the other end of the pin, the pin can easily bend and damage the pin. .

High-strength self-locking nuts are a category of self-locking nuts with high strength and reliability. It is mainly based on the introduction of European technology, which is used for road construction machinery, mining machinery, vibration machinery and equipment, etc. There are very few domestic manufacturers of such products.

It can be seen from the figure that no matter how the screw core swings, it will not fall off from the screw sleeve. This is because part of the bead 5 is stuck in the hole 6 of the screw sleeve 1 and the other part is stuck in the screw core 2. In the groove 8, it plays the role of positioning. If the screw sleeve rotates clockwise, the beads 5 can only slide in the groove 8 of the screw core 2 under the driving of the screw sleeve 1 and cannot drive the screw core 2 to rotate. If the screw sleeve 8 rotates in the opposite direction, the bead 5 will be stuck on the stop 7 of the screw core 2 so as to drive the screw core 2 to rotate.

The two combination screws are classified according to the national standard, including GB9074.2, GB9074.3, GB9074.5, etc. GB9074.3 refers to a two-component combination of a cross pan head screw and a foreign lock washer.

We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: nylon lock nuts, extended hexagon head self-tapping screws, small solid rivets, hollow screws and other products, we can provide you with suitable tightening screws Firmware Solutions.

Fine thread machine screw

Customized Level 12.9


The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].