Service HotlineIn the process of mechanical assembly, we often use pins to connect two parts, and the positioning pins are usually sunk into the pin installation holes on the mechanical parts. During the assembly process or after the assembly is completed, we often need to pull out the pins to assemble, revise or repair the parts. The existing method of pulling out the positioning pins is generally to use tools such as pliers, hand hammers, and blades to pull out the positioning pins, but This method is easy to damage the pin holes and pins, which will directly lead to the scrapping of the original parts. The positioning pin can be pulled out by pulling the pull rod, but in order to ensure the assembly accuracy between the parts, the matching between the positioning pin and the pin hole on the part is tight and the number of pins is large, so this method is inconvenient to operate. And time consuming.
screw is a common threaded connection part, which is mainly used to fix a part on the connection body. When it is necessary to connect, use the screw to pass through the hole on the connected parts, and screw the external thread on the screw into the connecting body to tighten it; The coupling part is separated from the coupling body. Existing common tools for screw disassembly and assembly are generally adjustable wrenches, open-end wrenches, Torx wrenches, socket wrenches, Allen wrenches, flat-blade screwdrivers, cross-shaped screwdrivers, etc., and a screw can only be disassembled with one or one type of tool. Assembly work; when the types of tools are not complete, the screw disassembly and assembly work is difficult to complete, and the screw disassembly and assembly work is greatly limited by the tools.
Due to the high demand for electronic products and the reduction of assembly line workers, in order to cope with the problem of labor shortage, manufacturing factories need to use automatic screw locking equipment to replace manual labor. In the existing automatic locking and paying equipment, most of them use a screw arranging machine to arrange the screws, and an electric screwdriver (electric batch) takes the screws back and forth, or the special equipment blows the screws into the electric batch to send the screws to the electric batch, and back and forth. The method of taking is too time-consuming, and the method of blowing air is not suitable for screws with small aspect ratios.
Bolt material: 18Cr2Ni4W, 25Cr2MoV steel; bolt specification: M27～M48. Because this kind of steel is easy to form a passivation film on the surface, and this passivation film will make the bolt unable to obtain a good adhesion chemical nickel phosphorus layer, so special pretreatment measures must be taken to remove the film first, and measures should be taken To prevent its regeneration, it is possible to ensure a good bonding force between the plated coating and the substrate. At the same time, due to the large geometric size of the bolt, it increases the difficulty of nickel-phosphorus plating treatment and quality inspection of the process.
T-bolts are often used in conjunction with flange nuts, which are standard supporting connectors when installing corner fittings, and can be automatically positioned and locked during the installation process. At present, in the welding process of T-bolts, there is often a method of manual welding. Using such a method, the manufacturing cycle is long, the labor intensity is high, the production efficiency is low, and the welding quality is difficult to guarantee.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: cross recessed mushroom head screws, small percussion rivets, scooter conversion screws, screw bolts and other products, we can provide you with suitable screws for you. Firmware Solutions.
