Service HotlineBolts with low hardness and strength. Generally, ordinary bolt materials are produced with ordinary screw wires. The hardness, strength, tensile strength and torsion force of ordinary bolt materials are not very high. High-strength bolts generally refer to high-strength bolts. Its own screw material, bolt material, and bolt material are relatively good, and the hardness is relatively high, and after the production is completed, the bolts will be hardened. Make the bolts meet the grade strength requirements of high-strength bolts.
Generally speaking, the metal plate needs to open holes for inserting the rivets, and then press the two sides of the metal plate along the positive direction of the metal plate with a jig, so that the metal plate is deformed in the plane direction, which makes the inner edge of the hole Shrink and fit the rivet. Existing riveting techniques are not suitable for thin sheets. Because the thin plate does not have enough thickness to compress in its forward direction, the insufficient deformation in the forward direction causes enough deformation in the plane direction to insert the rivet, so the rivet cannot be firmly fixed to the thin plate.
Pin riveting is an important procedure in the production process. At first, people used manual work, which has low production efficiency, high production cost, and high defect rate of products produced. Later, a pin riveting machine appeared. The pin riveting machine is a For riveting and pinning of hardware products, the pin riveting machine can complete the operation of pin loading and riveting pins, and the pin riveting machine reduces the process of pin loading and riveting pins in the hardware production process. However, its structural design is unreasonable and the operation is very inconvenient
Yueluo - a screw and nut disassembly tool for a narrow space, including a sleeve rod, a sleeve rod vertically arranged at one end of the sleeve rod, a connecting rod for fixedly connecting the sleeve rod and the sleeve rod, and a sleeve rod located at the end of the sleeve rod. The connecting rod in the axial through hole of the sleeve rod, the connecting rod located in the axial through hole of the sleeve rod, and the bearing for fixedly connecting the sleeve rod and the connecting rod and making the connecting rod rotate stably in the sleeve rod , and a sleeve head arranged at one end of the connecting rod, the connecting rod and the adjacent end of the connecting rod are provided with gears and the two gears are vertically meshed, so that when the external force drives the connecting rod to rotate, the force passes through The two gears and the connecting rod are transmitted to the sleeve head, thereby driving the screw or nut in the sleeve head to rotate;
Most of the electroplating used for rivet nuts on the market is environmental protection blue zinc, because the salt spray test time of environmental protection blue zinc can reach 72 hours, that is, three days. This kind of electroplating has a longer salt spray resistance time. In fact, for example, for electroplating white nickel, the salt spray time of white nickel is relatively short, and it usually rusts in a few hours, which is less than 10 hours. However, some can be oiled for electroplating white nickel, and the salt spray time of the rivet nut after oiling can be longer. S series rivet nuts are made of free-cutting iron, which is treated after heat treatment. CLS series rivet nuts are made of easy-to-cut stainless steel. The hardness of low-carbon steel plates without surface treatment must be less than 70RB, and the hardness of stainless steel plates must be less than 80RB.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: non-standard fastener screws, stainless steel bolts, flat washers and spring washers, manufacturers supply hand-tightened nuts and other products, we can provide you with The right fastener solution for you.
