Service HotlineA kind of nut provided by Yueluo. The nut is in the shape of a casing and is provided with a threaded section. The hole walls at both ends of the threaded section are respectively provided with an annular shape and two grooves, and the notch of the groove points to the hole core. The hole diameter at the notch of the annular groove at the front end of the screw-in direction is larger than the nominal size of the thread segment, and the hole diameter at the notch of the annular groove at the rear end of the screw-in direction is smaller than the nominal size of the thread segment.
Traditional rivet nuts are usually cylindrical, and special tools are required to complete the riveting operation between the workpiece and the sheet, and tools are completely required for locking. And in the actual production process, it is often encountered that there are square holes on the workpiece, and bolts need to be installed in the square holes, especially in the power cabinet and the control cabinet when the workpiece with prefabricated square holes is used as the main frame, due to Due to the special structure of the workpiece, the installation nut can only be inserted from the side, and the installation cannot be completed when the side installation space is limited, which brings inconvenience to the installation.
The beneficial effects of Guangdong Yueluo Hardware Industry Co., Ltd. are: in Guangdong Yueluo Hardware Industry Co., Ltd., the rivet fixing mechanism is used to temporarily fix and position the rivet, and the pressure cylinder is used to drive the movement of the final shaft, so that the insertion nozzle can be Insert the rivet located in the rivet fixing mechanism into the product. Guangdong Yueluo Hardware Industry Co., Ltd. adopts mechanical drive and transmission, which has a high degree of automation and high work efficiency.
In the prior art, after the screw is screwed into the workpiece, rust inhibitor is dripped on the edge of the screw to prevent rust in the later stage, but this traditional dripping method of rust inhibitor often produces rust inhibitor during the dripping process. Difficult to penetrate, or the problem that the anti-rust oil cannot penetrate due to the tight contact between the screw thread and the thread groove. In terms of material saving, the traditional anti-rust of screws often causes a lot of waste of anti-rust agent, and cannot achieve a good anti-rust effect of screws.
Among them, the pneumatic riveting machine is more commonly used. The pneumatic riveting machine is also equipped with a clamp for assembling the rivet. The existing clamp usually uses two rotating clamps for fastening and assembly, but the rotation easily causes the two clamps to buckle. Misalignment, thus affecting the assembly of the rivet.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: automotive anti-loose bolts, blackened and thickened fixing washers, hand-knocked rivets, copper rivets, miniature screws and other products, we can provide products such as You have the right fastener solution for you.
