Service HotlineFor a long time, the rivets used in general riveting, especially the ordinary rivets and bolts and other fasteners commonly used in steel structures such as vehicles and bridges, have low connection reliability, especially under alternating load and impact conditions. Looseness is easy to occur, the maintenance cycle is short, and the maintenance cost is high in the later period, which cannot meet the requirements of railway freight.
In some special occasions, both objects need to be riveted and have good waterproof performance. The existing rivets have poor waterproof performance and often have problems such as water seepage.
In the prior art, the screw suction device can be implemented in the following two ways. One is to use a magnet to magnetize the electric bit head, and the electric bit head is used to approach the screw, and the screw is stuck by the electric bit head, so that the function of picking up the screw can be realized; The vacuum generator is used to form a negative pressure in the screw guide groove, and the screw is sucked into the tube to realize the screw pickup. The disadvantage of this solution is that in the process of picking up the screws, the grooves of the screws cannot be aligned, which leads to the deviation or leakage of the screws. The disadvantage of this solution is that the screw with an aspect ratio of less than 1.8 is prone to suction and skew, and the stability is not high. It can be seen that the existing technology still needs to be improved and developed.
The gasket side of the above-mentioned nut assembly is in contact with the mounting surface. When the nut is tightened, the gasket squeezes the outer cone surface to make it shrink, and the cone tip faces the same direction as the nut, thereby preventing the nut from tightening, so that the nut fixing effect is not good, and at the same time When multiple nuts need to be superimposed and fixed, two adjacent nuts cannot interact with each other, resulting in poor fixing effect.
Standard screw is one of the fasteners commonly used for fastening and assembly. Standard screws and flat washers, grade A, and standard spring washers, are used in combination, and are widely used in the assembly of various products. For manufacturers who use combination screws in small and medium batches, the process of combining screws, spring washers and flat washers generally adopts the method of assembling screws by workers' bare hands. This method is tedious and repetitive, wastes human resources, is time-consuming and labor-intensive, and it is difficult to ensure the normal operation of the workshop. assembly progress. The screw assembly machines currently on the market can replace manual assembly screws, but this type of equipment has disadvantages such as bulky size, high cost, complex structure, inconvenient non-standard manufacturing and maintenance, high noise, and power consumption.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: round head inner bolts, cup head self-tapping bolts, diamond nuts, electric vehicle bolts and other products, we can provide you with suitable fastening products piece solution.
