What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
The rod end of the ceramic production equipment is installed with the rod shaft, and then fixed by the cylindrical pin. At present, it is purely manual installation. It is impossible to ensure that the cylindrical pin is kept horizontal during the installation process, and the installation pressure of the cylindrical pin cannot be sensed. The pressure is too large. Cracks in the rollers, too low pressure, and easy loosening of the metal cap; it is impossible to install three or more cylindrical pins at the same time, and it is difficult to align the cylindrical pins with the pin holes of the cylindrical pins, resulting in low efficiency.
M15 grounding screw used to fix the grounding wire on household appliances and other equipment, the stud is cylindrical, and the thread is perpendicular to the end surface (section). However, the screw holes on the equipment all have tapping guide grooves for sinking and guiding due to the manufacturing process requirements. When fixing the ground wire, if the screw is not positioned accurately (the screw is inclined), the screw is pressed down hard, which is easy to cause the screw and the screw. The screw hole bites the teeth, and after biting the teeth, it is easy to cause the screw to loosen or fall off, posing a safety hazard.
The retaining ring is a ring-shaped body with an opening, and the traditional processing method is stamping. That is, a plate-shaped material is selected and punched out on the plate-shaped material (a circular body, and then the middle of the circular body is punched to form a ring-shaped ring body.) The punched material in the middle cannot be used again. This results in a waste of material.
Gaskets are mechanical seals between two objects, usually used to prevent pressure, corrosion, and natural thermal expansion and contraction of pipes between two objects and leakage. Since machining the surface is not possible, irregularities can be filled with spacers. Gaskets are usually made from sheet materials such as pad paper, rubber, silicone rubber, metal, cork, felt, neoprene, rubber, fiberglass or plastic polymers such as Teflon. Gaskets for specific applications may contain asbestos. The existing gasket is easily deformed for a long time in use, and the gasket cannot play the role of making up the difference. In addition, during the use process of the gasket, the adhesion between the gasket and the nut or the mechanical surface becomes poor, resulting in a poor sealing effect.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
