What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
At present, with the development of my country's railway industry, many railway fastener systems involve T-bolts. The structure is shown in Figure 1. The dimensions that need to be inspected are head width A, head length B, and head straight table height. C. The height of the head slope D, the total length of the bolt E, and the major diameter of the bolt F. Due to the irregular shape of these places to be inspected, the measurement is difficult. The measurement of general measuring tools is not only slow, but also difficult to control human errors, resulting in some extreme upper limits and There are disputes and misjudgments about the size of the extreme lower limit when judging qualified and unqualified.
In the switchgear of high and low voltage power equipment, the surface of many switchgear shells is painted or sprayed with plastic, and the installation beams and other parts of the switchgear and the entire cabinet must be continuously grounded according to the requirements of switchgear standards to improve the safe use of equipment. Because the common screw, spring washer, flat washer and nut type structural connection between the surface of the shell and the metal mounting beam cannot meet the requirements of grounding continuity, in order to meet the requirements, the surface of the shell is painted or Before spraying, special grounding studs must be welded. With the increase of installation beams, the number of welded studs must also increase, which increases the complexity of the product processing technology, wastes man-hours and increases costs.
Fan rivets are specially designed for manual installation. They can be pulled in through the holes of the panel or the bottom frame. They are made of elastomer material with good toughness and can be installed quickly even in interference assembly. The design is clever and has elastic function. It is not easy to slide out after being pulled in with the corresponding aperture. The fan rivets are mainly used in the fixing of electronic computer case fans, heat sinks and chips, with anti-vibration and noise reduction.
Knurled copper nut, the specification is M5X8X12, the outer circle is 8.0MM, and the height is 12MM. Material: C3604 (ROHS PASS) brass. The thread still guarantees 6H accuracy. This knurled copper nut is used in power tools. Unlike other knurled copper nuts, the diamond pattern of this knurled copper nut is located in the middle of the product, and the diamond-shaped mesh knurled wheel edge The large outer circular step surface is rolled out of diamond-shaped flowers.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
