What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
In the repair process of the EDITION 700 gearbox, it is often necessary to replace the piston seal. When replacing the direct gear piston seal, the shaft spring retaining ring on it must be removed before the piston can be taken out for replacement. For the seal, since the piston return spring 3 presses the retaining ring 5 through the spring seat 4 (as shown in Figure 3), it cannot be taken out directly. It is necessary to press down the spring seat before taking out the retaining ring. Without special tools, it is not easy to remove the retaining ring. At present, it is a time-consuming, labor-intensive and unsafe job that requires multiple people to use a screwdriver and a prying board to forcefully squeeze and pry to remove the retaining ring.
rivet is a nail-shaped object used to join two parts or components with a through hole and a cap on one end. In riveting, the riveted parts are connected by their own deformation or interference. There are many types of rivets, and they are informal. Commonly used are R-type rivets, fan rivets, blind rivets, blind rivets, tree rivets, semi-circular head, flat head, semi-hollow rivets, solid rivets, countersunk head rivets, blind rivets, hollow rivets, these usually use their own deformation Connect the riveted parts. Generally less than 8 mm with cold riveting, larger than this size with hot riveting. But there are exceptions. For example, the nameplate on some locks is riveted by the interference between the rivet and the lock body hole.
Guangdong Yueluo Hardware Industry Co., Ltd. is a screwing fixture, including a bottom plate, a bearing seat and a hydraulic press are respectively installed on both sides of the top of the bottom plate, a bearing is installed inside the bearing seat, and the inner ring of the bearing is connected to the support The bottom end of the vertical rod is snap-connected, the top end of the supporting vertical rod is fixedly connected to the supporting horizontal rod through an adjusting screw, the bottom end of the supporting horizontal rod is provided with a chute, and the inside of the chute is connected by sliding The slider is fixedly connected with the electric batch, the hydraulic press is connected with the fixed seat through the hydraulic rod, the top of the fixed seat is fixedly connected with the screw positioning plate through two fixed blocks, and the opposite side of the two fixed blocks is provided with Clamping mechanism for clamping workpieces.
The t-bolt can be directly put into the groove of the aluminum profile. It can be automatically positioned and locked during the installation process. It is often used in conjunction with the flange nut. profiles to choose from. T-bolts are movable anchor bolts. The existing t-bolt is easy to rotate and swing in the slot during use, which brings some inconvenience to the use of the t-bolt.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
