What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
Blind rivets are a type of flying rivets for single-sided riveting, but they must be riveted manually, electrically, and automatically using special tools. This type of rivet is especially suitable for riveting occasions where it is inconvenient to use ordinary rivets and must be riveted from both sides, so it is widely used in construction, automobiles, ships, aircraft, machinery, electrical appliances, furniture and other products.
kind of screw provided by Yueluo, the rod body of the screw rod has a thread segment, one end of the thread segment is provided with an annular convex ring on the outer peripheral surface of the rod body, and the distance between the convex ring at the front end of the screw threading direction and the rod core Smaller than the nominal size of the threaded section or the distance from the rear end of the bead to the rod core in the screwing direction is greater than the nominal size of the threaded section.
The history of screws was broadcast in 1986. Our country formulated a new standard for standard parts, which is commonly known as the new standard in the business. The most used ones are GB5780, GB5781, GB5782, GB5783, GB5784. GB5780 is a hexagonal head thick shank half-thread screw, its accuracy grade is C-grade product, which can be replaced by GB5782 (GB5782 is a hexagonal head thick shank full-thread screw, and its accuracy grade is grade A and B.) GB5781 is a hexagonal head full-thread screw. Threaded screw, the accuracy grade is C grade product. It can be replaced by GB5783 (GB5783 is a hexagonal head full-tooth screw, and its accuracy grades are A and B). GB5784 is a hexagon screw with thin rod and half teeth.
Washers (spring) washers, circlips are elastic pads or card lock washers a washer that prevents bolts from loosening. The working principle of lock washers is very simple. It consists of two washers. The outside is a radial relief surface, and the inside is a helical tooth surface. When assembling, the inner helical tooth surfaces are opposite each other, and the outer radial raised surface is engaged with the contact surfaces at both ends. When the connecting piece is vibrated and the bolt tends to loosen, only the inner helical tooth surfaces of the two washers are allowed to face each other. Staggered movement, resulting in lifting tension, so as to achieve 100% locking.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
