What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
In the prior art, spring pads are fixed to the seat pan or to the height adjuster tube. However, in the absence of a seat pan, additional components are required to secure the spring pads to prevent movement of the spring pads in the longitudinal direction of the vehicle. FIG. 1 shows such a seat spring pad 2 , which is fixed to the seat pad 1 by means of additional fixing parts 4 . Additional weight is added due to the use of additional fixing parts and a separate step is required in the assembly process to connect the fixing parts to the spring pads. During use, there may be noise between the spring cushion and the seat cushion
Nuts are parts that tightly connect mechanical equipment. Through the inner thread, nuts and bolts of the same specification can be connected together. At present, most nuts are used together with gaskets when they are locked, or are set as an integrated structure, which has the advantage of increasing Friction, strengthen the effect of tightening, but the square nut is usually used directly without adding a gasket, and the upper and lower end faces are flat, very smooth, when subjected to strong vibration, it is very easy to loosen, and the tightening effect is not good.
Commonly used national standard GB41Ⅰ type hexagon nut——C grade GB6170Ⅰ type hexagonal nut——, B grade GB6171Ⅰ type hexagonal nut-fine thread-, B grade GB6172 hexagonal thin nut——, B grade - chamfering GB6173 hexagonal thin nut—— Fine thread—, B grade GB6174 hexagonal thin nut—B grade—without chamfering
The rod end of the ceramic production equipment is installed with the rod shaft, and then fixed by the cylindrical pin. At present, it is purely manual installation. It is impossible to ensure that the cylindrical pin is kept horizontal during the installation process, and the installation pressure of the cylindrical pin cannot be sensed. The pressure is too large. Cracks in the rollers, too low pressure, and easy loosening of the metal cap; it is impossible to install three or more cylindrical pins at the same time, and it is difficult to align the cylindrical pins with the pin holes of the cylindrical pins, resulting in low efficiency.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
