What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
Convex washers are mainly punched out of iron plates. The shape is generally a flat washer with a hole in the middle. Flat washers are usually thin pieces of various shapes to reduce friction, prevent leakage, isolate, prevent loosening or Dispersing pressure, the rationality of its design structure and the safety during use are very important.
With the mass production of large-scale equipment, standardization, and the concept of lean production, it has become more and more important to improve the efficiency of the assembly stage. Nowadays, when assembling small equipment, power tools and automatic bolt supply devices are basically popular, but only for M3 and smaller However, large equipment is often fastened with M8 or larger diameter bolts, and it is still in the process of combining manual and air tools. Among them, the pre-installation of the flat and spring washers on the bolts is completely manual operation. When the bolts need to be tightened in large quantities, the shortcomings of low efficiency are particularly obvious, and the flat and spring washers are easy to be scattered when manually assembled, and there are mixed installations of different specifications. Problems such as less installation and missing installation will affect the processing quality.
Most electrical appliance manufacturers only require the size and riveting gap to be tested for riveted contact components. There is no clear requirement for riveting strength. Only a few manufacturers perform torsion testing on riveting strength. The torque detection method is as follows: use a saw blade to open a one-shaped groove on the rivet head of the riveted contact element, and then insert a torque wrench into the one-shaped open groove to rotate, and measure the torque value. Because most of the electrical contacts are made of copper-silver alloy, the strength is low, and it is easy to slip during the test, and when a saw blade is used to open the one-shaped groove, the width and depth cannot be accurately positioned, so the measured value fluctuates greatly. , has always been an unsolvable technical problem in the industry.
Currently, a screw generally includes a shank body, a threaded portion formed on the outer edge of the shank body, and a conical head formed at the rear end of the shank body. When the current thread is in use, since the thread part is cylindrical, the thread part and the workpiece are vertical, so it is relatively laborious when in use, and it is difficult to locate, lock and unlock.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
