What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
The four corners of the bolt head of the traditional T-slot connection bolt are all rounded corners, which will make the contact area between the bolt and the T-slot too small and reduce the connection fastness, especially when used for connection. When aluminum or copper profiles are used, due to the low hardness of the material, it is more likely to cause deformation of the T-shaped groove and affect the connection effect. Furthermore, since the traditional T-bolt has no direction indicator, it is difficult for the installer to identify the installation state during installation.
There are two typical pin shearing fixture tooling, among which the traditional fixture shown in Fig. 1 is more complicated and consists of fixture, spacer, washer and shearing block guide post, hardened bushing, shearing block and so on. The cylindrical pin is installed in the hardened bushing, and the axial load is applied through the shear block to complete the shear test. The fixture is complicated in manufacture and has many consumables, because the size of the hardened bushing is similar to that of the cylindrical pin. , and to keep the notch of the cylindrical pin upward, it is difficult to install before the test, and the broken cylindrical pin after the test remains in the hardened bushing and is difficult to remove.
Embedding of fasteners, especially screws. The main point of the structure is that it includes an annular base, one at the base and a plurality of cylindrical tubes on the base, and the cylindrical tubes and the cylindrical tubes on the base are connected by ribs. Cylindrical tubes are used as fixing holes and fastener pre-embedded holes respectively. The product is fixed on the formwork that needs to use screw points through the fixing holes. After the concrete is poured into the floor, the embedded screw parts are pre-embedded, and the floor has embedded screw holes for hanging the installation objects with screws. . Avoid future re-drilling damage to the wall and floor. Guangdong Yueluo Hardware Industry Co., Ltd. has a simple and scientific structure, easy pre-embedding, strong tensile strength and firmness.
With the mass production of large-scale equipment, standardization, and the concept of lean production, it has become more and more important to improve the efficiency of the assembly stage. Nowadays, when assembling small equipment, power tools and automatic bolt supply devices are basically popular, but only for M3 and smaller However, large equipment is often fastened with M8 or larger diameter bolts, and it is still in the process of combining manual and air tools. Among them, the pre-installation of the flat and spring washers on the bolts is completely manual operation. When the bolts need to be tightened in large quantities, the shortcomings of low efficiency are particularly obvious, and the flat and spring washers are easy to be scattered when manually assembled, and there are mixed installations of different specifications. Problems such as less installation and missing installation will affect the processing quality.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
