What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
In the design of electrical products, in order to avoid the problem of electromagnetic radiation interference, it is necessary to isolate the conduction between metal parts (parts). Especially when the metal parts are locked by metal screws, the conduction between the locked pair of metal parts (parts) is often caused, so it is necessary to try to isolate them. For example, when screws are used to lock the structure iron of the liquid crystal display screen and the iron structure of the foot base, the electromagnetic waves generated by the liquid crystal display screen are easily radiated from the foot base, causing electromagnetic radiation interference.
Standard spring washer (GB/T93-1987) Light spring washer (GB/T859-1987) Heavy spring washer (GB/T7244-1987) Spring washer is also known as spring meson. Saddle spring washer (GB/T 7245-1987) Saddle spring washer (GB/T 860-1987) Wave spring washer (GB/T 7246-1987) Wave spring washer (GB/T 955-1987)
The purpose of Guangdong Yueluo Hardware Industry Co., Ltd. is to overcome the above-mentioned shortcomings of the prior art, and provide a hidden screw fastener, which avoids the defect that the screw end cap is directly exposed when the traditional screw is tightened, which affects the appearance. Washers and shields hide the end caps of the screws, which are both beautiful and insulating, preventing the screws from rusting, and avoiding scratches due to burrs on the ends of the screws, which are not only beautiful but also practical and safe.
Installation method broadcast 1. One-time burying method: When pouring concrete, bury the anchor bolts. When the high tower is controlled by overturning, the anchor bolt should be buried once. 2. Reserved hole method: The equipment is in place, the holes are cleaned, the anchor bolts are placed in the holes, the equipment is positioned and aligned, and then poured with non-shrinkage fine stone concrete that is one level higher than the original foundation, and compacted and compacted. . The distance from the center of the anchor bolt once buried to the edge of the foundation should not be less than 2d (d is the diameter of the anchor bolt), and should not be less than 15mm (d≤20, it should not be less than 10mm), not less than half the width of the anchor plate Add 50mm, when the above requirements cannot be met, appropriate measures should be taken to strengthen it. The diameter of the anchor bolts used for the structure should not be less than 20mm. When subjected to earthquake action, double nuts should be used for fixing, or other measures to effectively prevent loosening should be adopted, but the anchorage length of anchor bolts should be increased by 5d compared with the anchorage length of non-seismic action. Installation planning of anchor bolts Treatment of anchor bolts loose in the foundation When the anchor bolts are tightened, the bolts may be pulled out. At this time, the bolts should be adjusted to their original positions, and the foundation around the bolts should be shoveled out enough. , and then weld two U-shaped steel bars vertically and horizontally on the bolts, and finally clean the pit with water and grouting, and then tighten the live anchor bolts after the concrete has solidified to the design strength. The treatment method of the live anchor bolt deviation is roughly the same as the dead ground. The method for the anchor bolts is the same, except that the anchor bolts can be pulled out for processing. If the bolt is too long, a section of the thread can be cut off on the machine tool; if the bolt is too short, it can be extended by hot forging; if the position is inconsistent, it can be corrected by bending. Application industry: suitable for various equipment fixing, steel structure foundation embedded parts, street lights, traffic signs, pump, boiler installation, heavy equipment embedded fixing, etc.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
