What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
The grooved embedded parts are pre-embedded in concrete, and then placed in the groove with T-bolts. After adjusting the fixed position, the fixed object is locked with a nut to achieve the fixing effect. When the grooved embedded parts are embedded vertically in the concrete or at a certain angle to the horizontal line, the T-bolts are likely to move in position before they are tightened. In particular, when fixing heavy equipment, multiple T-bolts are required, and multiple groups of workers are required to help and positioning is difficult, and the installation process is complicated.
In view of the deficiencies of the prior art, Guangdong Yueluo Hardware Industry Co., Ltd. provides a relatively simple screw that can be manually disassembled. In order to achieve the above purpose, Guangdong Yueluo Hardware Industry Co., Ltd. provides the following technical scheme: a screw that can be disassembled manually, including a stud and a nut, and the axial direction of the screw is provided with a screw extending from the nut to the stud. A groove, a control column that is slidably matched with the groove is arranged in the groove, a through groove is opened on the circumferential side wall of the control column, and a circumferential side wall of the control column is provided with a parallel to the axis of the control column. A limit bar, the side wall of the groove is provided with a limit groove that cooperates with the limit bar, the control column is provided with a accommodating groove, and the accommodating groove is provided with a rotating rod that cooperates with the through groove, so The accommodating groove and the rotating rod are arranged separately. Further, a accommodating groove is opened at the corresponding groove on the nut, a baffle is hinged on the side wall of the accommodating groove, and a torsion spring is provided at the hinged joint between the baffle and the accommodating groove.
In the repair process of the EDITION 700 gearbox, it is often necessary to replace the piston seal. When replacing the direct gear piston seal, the shaft spring retaining ring on it must be removed before the piston can be taken out for replacement. For the seal, since the piston return spring 3 presses the retaining ring 5 through the spring seat 4 (as shown in Figure 3), it cannot be taken out directly. It is necessary to press down the spring seat before taking out the retaining ring. Without special tools, it is not easy to remove the retaining ring. At present, it is a time-consuming, labor-intensive and unsafe job that requires multiple people to use a screwdriver and a prying board to forcefully squeeze and pry to remove the retaining ring.
At present, with the development of the manufacturing industry, many parts with strange shapes are widely used in aviation, aerospace and other industrial fields, one of which is an L-shaped cylindrical pin. The upper end is provided with a 2.55×4.95 U-shaped boss. The parallelism error between the upper end face and the lower end face of the boss is required to be less than 0.01 mm. The L-shaped cylindrical pin requires high machining accuracy and is difficult to clamp on the machine tool. It is difficult to process. When the forming part is cut off, the cut surface, that is, the upper end surface of the boss, will leave a small column platform. When processing this end surface, in the prior art, a vise is generally used to process such an L-shaped cylindrical pin. Or copper sleeves are clamped, and then processed; however, due to the small size of the parts, the L-shaped cylindrical pin workpiece is difficult to clamp; due to the high precision required for each machined surface of the workpiece, when clamping with a vise , the clamping force of the vise is difficult to control, and it is easy to crush and scratch the surface of the workpiece; and when using a vise or a copper set clamp, only one workpiece can be clamped for each processing and production, and it is difficult to ensure the upper and lower planes of the parts after the clamping is completed. Parallelism machining error, resulting in low parts processing quality and low production efficiency.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
