What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
The flat gasket product is an accessory on the high-speed rail backing plate. The product requires two planes to be flat, the shape and size of the inner hole are accurate, and there are no casting defects (such as air holes, shrinkage holes, sand holes, etc.), and the casting material requires GB/T450-10 . Due to the light weight and large demand of flat gaskets, if they are produced by ordinary sand casting process, the castings are prone to deformation, sand holes, air holes and other casting defects, and the molding area is large, the production efficiency is low, and the production tasks are difficult to complete.
Many parts on the car need to be rubberized, which can reduce noise, especially the parts related to shock absorption. Nuts are welded on many of these parts to facilitate the installation of other parts on them. The sheet metal is generally relatively thin, and most of them are only one or two millimeters. A through hole is punched, and then the nut is placed in the hole, and then around it. Spot welding is done so that it can be fixed. After spot welding, the periphery of the screw hole on the sheet metal will not be flat due to thermal deformation, which will affect the appearance.
rivet assembly device is provided with a base, the middle of the base is provided with a vertical groove, the bottom wall of the vertical groove extends forward and a horizontal convex block is suspended; the top surface of the convex block is fixed with a vertical rivet Needle and a guide column, the column body of the guide column is covered with a return spring; a downwardly open sliding block is mounted on the convex block, and the upper ends of the rivet needle and the guide column respectively protrude into the sliding block on the top wall of the sliding block. In the riveting pin hole and the guide hole, the inner wall of the riveting pin hole is provided with a large upper and a lower small horizontal step; the upper part of the bottom wall of the vertical groove is provided with a guiding limit rib. Guangdong Yueluo Hardware Industrial Co., Ltd. sets the rivet needle under the workpiece, and uses the upper die punch to press down the workpiece, and the rivet needle completes the operation of the rivet, omitting the operator to turn over and carry the rivet terminal board, thus effectively avoiding the rivet from The phenomenon that the rivet hole comes out. In addition, during operation, the workpiece is placed on the top surface of the slider, and the workpiece guide limit ribs and guide columns are used as shafts and radial limiters respectively. The riveting quality is good, and the purpose of saving time and labor and high efficiency is achieved.
The function of the waterproof gasket is mainly to prevent the leakage of liquid or gaseous substances and the intrusion of external liquids, and has achieved the effect of sealing. Generally, the waterproof gasket is simply designed in the shape of a rubber ring plate.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
