What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
Process equipment for aircraft production (hereinafter referred to as tooling) is directly used for part forming and component assembly. In order to satisfy the loading and unloading of aircraft parts and components during the use of the tooling, the tooling generally adopts a structural form that is easy to disassemble as a whole. In the field of aircraft process equipment manufacturing, positioning pins are usually used to connect and position the detachable parts of the tooling. At present, this kind of locating pin is divided into two types: direct pull-out locating pin and tie-suspended locating pin.
The use of stainless steel screw lines: The hardness of stainless steel screw lines causes them to have different uses. Generally, they are used as small screws in life, but also as car screws and compression screws. They are widely used in normal life. Types of stainless steel screw lines: In appearance, screw lines are generally divided into fog surface spring lines and bright surface screw lines. The hardness of matte surface screw lines is higher than that of bright surface screw lines. For products with low appearance requirements and relatively high elasticity requirements. Paper, oxalic acid, fertilizer and other production equipment; photography, food industry, facilities in coastal areas, ropes, CD rods, bolts, nuts.
In the prior art, the independent pocketed spring is to encapsulate the springs in bags independently, connect each independent pocketed spring side by side, and then cover it with a large non-woven fabric to form a Spring cushions. This spring mat structure has many disadvantages: 1. Uneven force and low hardness; 2. Easy to deform, pit, low flatness and unsightly; 3. The spring directly contacts the non-woven fabric, causing wear and tear, and the life of the spring mat relatively short.
Nuts are used as fasteners, and most of them need to be used in conjunction with gaskets in the process of use to adjust the deficiencies of the material itself and strengthen the degree of tightening, while metal materials are used as raw materials for gaskets. The cost is also relatively high, and in the process of use, the end face of the metal gasket and the nut will also be affected by the process, resulting in the defect that the fastening effect is not firm and easy to loosen.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
