What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
A low-carbon steel rivet nut fastener composed of a brim, a deformed skirt and a threaded wire hole is characterized in that there are fish teeth below the brim; the outer side of the lower end of the threaded wire hole has a chamfer; the inner wall of the threaded wire hole The cross section of the thread is an isosceles trapezoid, and the upper bottom of the trapezoid is a concave arc.
The purpose of Guangdong Yueluo Hardware Industry Co., Ltd. is a kind of anti-loosening cylindrical pin with grooves specially designed for the multi-link transmission paint mixing mixer, which is specially designed for the problems existing in the above-mentioned prior art. The purpose of Guangdong Yueluo Hardware Industry Co., Ltd. is to realize through the following technical solutions: a kind of anti-loose cylindrical pin with groove, wherein: a plurality of axial V-shaped grooves are provided on the cylindrical pin, and the V-shaped groove Arrange evenly on cylindrical pins. There are three to four axial V-shaped grooves on the cylindrical pin. When Guangdong Yueluo Hardware Industry Co., Ltd. is in use, the cylindrical pin with V-shaped groove is installed in the vertical shaft, and cooperates with the U-shaped groove on the connecting rod to transmit torque. The cylindrical pin of the V-groove structure is an interference fit with the mounting hole of the vertical shaft. The biggest feature of Guangdong Yueluo Hardware Industry Co., Ltd. compared with the existing technology is that the cylindrical pin is used as a vertical shaft to connect with the connecting rod for torque transmission, which gives full play to the impact resistance and fatigue resistance of the cylindrical pin. The cylindrical pin has an interference fit with the pin hole, and each edge of the V-groove structure distributed on the cylindrical pin body will penetrate into the inner wall of the pin hole to prevent loosening.
Before the special vehicle is refitted, the chassis and the car frame should be reinforced again, and the fastened part of the rivets should be disassembled before the car frame is reinforced.
The process of removing iron oxide plate from cold heading steel wire rod is stripping and dephosphorization. There are two methods: mechanical dephosphorization and chemical pickling. Replacing the chemical pickling process of wire rod with mechanical phosphorus removal not only improves productivity, but also reduces environmental pollution. This phosphorus removal process includes bending method (the round wheel with triangular grooves is commonly used to repeatedly bend the wire rod), spray nine method, etc. The phosphorus removal effect is good, but the residual iron and phosphorus cannot be removed (the removal rate of iron oxide scale is 97%) ), especially when the iron oxide scale is very sticky, therefore, mechanical phosphorus removal is affected by iron scale thickness, structure and stress state. Carbon steel wire rods used for low strength fasteners (less than or equal to 6.8) High-strength bolts (greater than or equal to grade 8.8) use wire rods to remove all iron oxide scales after mechanical dephosphorization, and then go through a chemical pickling process for compound dephosphorization. For low carbon steel wire rods, the iron sheets left by mechanical dephosphorization are likely to cause uneven wear of grain draft. When the grain draft hole adheres to the iron sheet when the wire rod rubs against the external temperature, the surface of the wire rod produces longitudinal grain marks. More than 95% are caused by scratches on the surface of the steel wire during the drawing process. Therefore, the mechanical phosphorus removal method is not suitable for high-speed drawing.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
