What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
After the centrifugal fan blade is assembled in the square cabinet, it needs to be fixed with nuts. The components needed to fix the centrifugal fan blades are gaskets, washers and nuts. During the operation, it is necessary to assemble the gasket, washer and nut in sequence, then drip the fastening glue, and then fix it.
Metric threads are measured in MM (millimeters) and have a cusp angle of 60 degrees. Both US and Imperial threads are measured in inches. The cusp angle of the American thread is also 60 degrees, while the cusp angle of the imperial thread is 55 degrees. Due to the different units of measurement, the representation methods of various threads are also different. For example, M16-2X60 represents a metric thread. His specific meaning is that the nominal diameter of the screw is 16MM, the pitch is 2MM, and the length is 60MM. Another example: 1/4—20X3/4 means the inch thread, what he specifically means is the nominal diameter of the screw It is 1/4 inch (one inch = 25.4MM), there are 20 teeth on one inch, and the length is 3/4 inch. In addition, if you want to express American screws, UNC and UNF are usually added to the back of the British screws to distinguish between American coarse teeth or American fine teeth. In the usual domestic sales business, the most common standards we encounter are GB (National Standard) and DIN (German Standard). In the production of Yaoda, the following standards are mainly encountered: GB30; GB5783; GB5782; GB52; GB6170; GB818; GB819; GB845; GB846; GB70; DIN912; DIN933; It has been replaced by GB5783 (new national standard). GB52 (old national standard) has been replaced by GB6170 (new national standard) in the standard book.
The rivet provided by Yueluo Creation includes a mandrel and a coaxial matching nail sleeve outside the mandrel; the mandrel includes a head, a central rod and a tail, and a position close to the head is provided with an inner A concave section of the lock ring area, a position close to the tail is provided with a section of lock area that inclines and shrinks inward along the direction of the head to the tail; the lock ring area of the core rod is gap-fitted and fixed with a lock ring , a part of the lock ring is located inside the sleeve head of the nail sleeve, and the part of the lock ring located outside the sleeve head of the nail sleeve can be interference fit with the nail sleeve; the nail sleeve The sleeve is provided with a through hole for the core rod to penetrate into, the inner wall of the nail sleeve forming the through hole is provided with a protruding structure, and one end of the protruding structure is close to the sleeve head of the nail sleeve The end of the core rod is close to or adjacent to the end of the tail of the core rod.
In order to solve this technical problem, Yueluo Company provides an adjusting nut, which includes a bearing unit, a thrust washer, an adjusting nut and a snap ring. The inside of the adjusting nut is an internal thread structure, and one end of the internal thread structure is provided with Ring groove, the snap ring is pressed into the ring groove with interference, and is rigidly connected with the adjusting nut without relative movement; the bearing unit is supported on the shaft, and the thrust washer is in plane fit with the bearing unit; the adjusting nut and the shaft are threadedly connected , Fit with the thrust washer plane, the inner diameter of the snap ring and the thread of the shaft are in interference fit.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
