What is the tolerance range of precision screws?
What is the tolerance range of precision screws?
High-strength bolt connection has the advantages of simple construction, good mechanical performance, disassembly and replacement, fatigue resistance, and no loosening under dynamic load. It is a promising connection method. High-strength bolts use a special wrench to tighten the nut, so that the bolt generates a huge and controlled pre-tension. Under the action of pre-pressure, a large frictional force will be generated along the surface of the connected parts. Obviously, as long as the axial force is less than this frictional force, the components will not slip and the connection will not be damaged. This is the high-strength bolt connection. principle. High-strength bolted connections rely on the friction between the contact surfaces of the connectors to prevent them from sliding each other. In order to make the contact surfaces have sufficient friction, it is necessary to increase the clamping force of the components and increase the friction coefficient of the contact surfaces of the components. The clamping force between the components is achieved by applying pretension to the bolts, so the bolts must be made of high-strength steel, which is why it is called high-strength bolted connections. In high-strength bolted connections, the friction coefficient has a great influence on the bearing capacity. Tests show that the coefficient of friction is mainly affected by the form of the contact surface and the material of the components. In order to increase the friction coefficient of the contact surface, methods such as sandblasting and wire brush cleaning are often used to treat the contact surface of the components within the connection range during construction.
The flange nut and the general hexagon nut are basically the same in size and thread specification, but compared with the hexagon nut, the gasket and the nut are integrated, and there are anti-skid tooth patterns on the bottom, which increases the nut and the workpiece. Compared with the combination of ordinary nut and washer, it is stronger and has greater tensile force. In some equipment with large vibration amplitude, due to the action of huge vibration force, the flange nut is prone to loosening, which often occurs. If the flange nut falls off the equipment or even damages, the staff also needs to install the flange nut repeatedly, which increases the labor intensity and brings great inconvenience to the use. Now a split type tightening nut is proposed.
Guangdong Yueluo Hardware Industry Co., Ltd. relates to a square nut fastener for cable bridge installation, which is characterized in that it includes an upper plate body and a U-shaped jacket, and the upper plate body is provided with a downwardly protruding connecting cylinder, The two side plates of the U-shaped jacket are connected to the connecting cylinder, and the center line of the two side plates is located on the center line in the length direction of the upper plate body; the bottom of the U-shaped jacket is a wave-shaped elastic plate, which is a wave-shaped elastic plate It is fixedly connected on the two side plates, and the space enclosed by the two side plates of the U-shaped jacket, the wave-shaped elastic plate and the bottom of the connecting cylinder is the installation position of the square nut. Guangdong Yueluo Hardware Industry Co., Ltd. has a simple and reasonable structure, and is extremely convenient and flexible to operate; it does not occupy the bottom space of the C-shaped steel after installation, which increases the variety of installation, and can be applied to square nuts of different thicknesses, and the installation is firm.
Some electronic products need to install some plastic parts or protective sleeves for components on the PCB, which need to be fixed by screws. The function of the fixture is to locate the PCB and the required installation parts, and increase the work efficiency. The existing screw fixture is inconvenient According to the needs of the site, the positioning station of the screw can be changed, the accurate positioning of the screw is difficult and the clamping effect of the workpiece is poor. A screw jig is proposed.
The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].
